High-performing smoke extract fans for harsh working conditions in the event of a fire.
400°C/120 min (F400): Tested according to EN 12101-3 at LGAI Barcelona.
Continuous medium temperature up to 55°C.
Acoustic and thermal insulation 20 mm
Indoor and outdoor installation
Flexible airflow direction due to removable panels
The smoke extract units MUB/F are used in case of fire to extract smoke gases and also during normal working conditions for standard temperature up to 55°C continuously.
The MUB/F fans are intended to use for extract air, designed to be installed in any position.
The MUB/F fans are designed for straight through airflow but can easily be rebuilt due to removable panels. Construction of casing and thermal insulation permits outdoor and indoor use.
The casing consists of a frame, manufactured from profiled steel, 4 double skin panels from galvanized steel and 20 mm mineral wool insulation inside.
High performed impeller covering the most modern technology.
The casing consists of a steel frame, manufactured from profiled steel, 4 double skin panels from galvanized steel and 20 mm mineral wool insulation inside.
The fan inlet side is equipped with an inlet cone and a circular connection spigot with rubber sealings.
The fan outlet panel, which can easily be changed at site from straight through air direction to top or side outlet, is equipped with a circular connection spigot, same connection diameter as on the fan inlet.
The MUB/F fans use radial impeller with backward curved blades. These are manufactured out of galvanized steel, dynamically balanced and paired with corresponding IEC motors with efficiency IE3.
High temperature motors for temperature classification F400 (400°C/120 min). Available as single-speed or two-speed.
Motor protection can be realized by the over current device from the frequency converter, for example.
The motor can be controlled by AES control unit or frequency converter.
The MUB/F fans can be installed in any position indoor and with weather protection roof also outdoor.
Multibox smoke extraction fan for hot smoke extraction 400°C/120 min (F400). Direct installation in duct systems. Casing consists of a frame, manufactured from galvanised steel profiles. Double skin galvanised steel panels, thermally and sound insulated with a 20 mm layer of mineral wool, smooth inner sides. The complete casing is resistant to the effects of seawater. Free-running, backward curved centrifugal impeller made of galvanised steel sheet. Impeller acc. to VDI 2060, balancing quality Q 6.3, dynamically balanced in two planes acc. to ISO 1940 T1. Internal rotor motor (IP55), single speed, motor protection on site. Terminal box fitted on the motor. Suitable for medium temperatures up to 55°C in continuous operation. Multifunctional use. Variable outlet direction, can be modified on site. Variable installation position. Installation either inside or outside the fire zone without additional insulation Tested to EN 12101-3. certificate available.